@article {7774,
	title = {High-performance 3D printing of hydrogels by water-dispersible photoinitiator nanoparticles},
	journal = {Sci AdvScience advances},
	volume = {2},
	number = {4},
	year = {2016},
	note = {MEDLINE AN 2016877417(Journal; Article; (JOURNAL ARTICLE))},
	month = {2016///},
	pages = {e1501381},
	abstract = {In the absence of water-soluble photoinitiators with high absorbance in the ultraviolet (UV)-visible range, rapid three-dimensional (3D) printing of hydrogels for tissue engineering is challenging. A new approach enabling rapid 3D printing of hydrogels in aqueous solutions is presented on the basis of UV-curable inks containing nanoparticles of highly efficient but water-insoluble photoinitiators. The extinction coefficient of the new water-dispersible nanoparticles of 2,4,6-trimethylbenzoyl-diphenylphosphine oxide (TPO) is more than 300 times larger than the best and most used commercially available water-soluble photoinitiator. The TPO nanoparticles absorb significantly in the range from 385 to 420 nm, making them suitable for use in commercially available, low-cost, light-emitting diode-based 3D printers using digital light processing. The polymerization rate at this range is very fast and enables 3D printing that otherwise is impossible to perform without adding solvents. The TPO nanoparticles were prepared by rapid conversion of volatile microemulsions into water-dispersible powder, a process that can be used for a variety of photoinitiators. Such water-dispersible photoinitiator nanoparticles open many opportunities to enable rapid 3D printing of structures prepared in aqueous solutions while bringing environmental advantages by using low-energy curing systems and avoiding the need for solvents.[on SciFinder (R)]},
	keywords = {3d printing, Hydrogels, photoinitiator, tpo, uv curing},
	isbn = {2375-2548},
	author = {Pawar, Amol A. and Saada, Gabriel and Cooperstein, Ido and Larush, Liraz and Magdassi, Shlomo and Jackman, Joshua A. and Tabaei, Seyed R. and Cho, Nam-Joon}
}
